Page 8 of 10

Re: Shakespheare?

PostPosted: Mon Apr 11, 2016 10:09 pm
by floater
My tray is the later type without a cobra head plug, instead it has an oval cutout at the back above the fuel connection through which the loom and power cables pass. The loom should go to a multi pin plug on the side of the airbox but mine is a little different. The pressure tube goes down to the floor of the tray then back to join the loom and cables and lays in a natural hollow between the cables in the oval cutout to exit. The nylon tube is quite tough so will not kink until it is forced to quite a tight radius.

Re: Shakespheare?

PostPosted: Tue Apr 12, 2016 6:09 pm
by haventaclue
Thanks again Floater.I'll try through the hole that is there,maybe try and elbow if beat.Will be a couple of days as axle of trailer for derusting and painting,and let me tell you a snipe trailer with boat on axle stands,is not the steadiest of platforms :shock:

Re: Shakespheare?

PostPosted: Sun Apr 17, 2016 8:22 pm
by Wikingboat
New seats and steering and sprig time. :woo:

Re: Shakespheare?

PostPosted: Mon Apr 18, 2016 10:25 pm
by Wikingboat

Re: Shakespheare?

PostPosted: Tue Apr 19, 2016 6:46 am
by Wikingboat

Re: Shakespheare?

PostPosted: Sun Apr 24, 2016 9:54 pm
by Wikingboat
I made torque tammer, lift Mariner 1 inch. Getting better and better
58 knots -->
http://youtu.be/QVhj7Czziyc

Re: Shakespheare?

PostPosted: Mon Apr 25, 2016 9:05 pm
by haventaclue
That is nice speed. :notworthy: I'm happy to get 35knots out of my auld '69 Merc800.

Re: Shakespheare?

PostPosted: Tue May 03, 2016 6:55 am
by Wikingboat
Testing Merc Chopper 24", 6500 revs, 59 knot.
http://youtu.be/f1NjuLE2294

Re: Shakespheare?

PostPosted: Tue May 03, 2016 8:35 am
by Wikingboat
Sahke US ready.jpeg

Interior is almost ready.
Sahke US ready.jpeg

Re: Shakespheare?

PostPosted: Wed May 25, 2016 10:08 am
by Wikingboat