Can anyone confirm the diameter of my prop ?
I think its 10 "+ a fraction, like 10 3/4" but just dont know.
ref on prop 48 73144 A4 17p, I know its 17" pitch but what diameter, cant find it in any of my manuals
Merc 50hp prop diameter ?
- Tremlett 15
- Posts: 659
- Joined: Fri Feb 06, 2009 1:24 pm
- CMBA Member: 73
- Location: Bangor, Co Down, Northern Ireland
- Rapier
- Site Admin
- Posts: 13940
- Joined: Thu Feb 05, 2009 5:16 pm
- CMBA Member: 569
- Location: West Glos
Re: Merc 50hp prop diameter ?
The EPC for that part isn't specific about it's diameter either.
Fasten bra straps and remove dentures...
Re: Merc 50hp prop diameter ?
Going by my mercury table for that part number its a 10" x17", going by the same chart, the largest diameter of any pitch for your motor is 10 7/8", so if you find a stainless steel prop for your motor with the diameter anywhere between 10"-10 7/8" it should fit.
- Tremlett 15
- Posts: 659
- Joined: Fri Feb 06, 2009 1:24 pm
- CMBA Member: 73
- Location: Bangor, Co Down, Northern Ireland
Re: Merc 50hp prop diameter ?
se7en wrote:Going by my mercury table for that part number its a 10" x17", going by the same chart, the largest diameter of any pitch for your motor is 10 7/8", so if you find a stainless steel prop for your motor with the diameter anywhere between 10"-10 7/8" it should fit.
Thanks se7en, it was in the back of my head as 10" or 10" + a SMALL fraction,
enjoy your trip.