JBASCO IMPELLER REPLACEMENT?
Posted: Wed May 09, 2018 7:45 pm
Hi Chaps..
My Impeller is in bits!!...i have ordered two new ones so no problem with replacement except i cannot remove whats left,its the middle bit that sits on the shaft..i can see a very small pin? there is no slot in the shaft so it dosnt just push on or pull off ! does anyone know how to remove this...is it the pin thats stopping it ? if it is a pin ? on the cap it says 1/4-400 the pump is bolted to a 100e engine now off...its the last thing stopping me going in the water...it may have never been changed..i really dont know...TIA ..
MEL.
My Impeller is in bits!!...i have ordered two new ones so no problem with replacement except i cannot remove whats left,its the middle bit that sits on the shaft..i can see a very small pin? there is no slot in the shaft so it dosnt just push on or pull off ! does anyone know how to remove this...is it the pin thats stopping it ? if it is a pin ? on the cap it says 1/4-400 the pump is bolted to a 100e engine now off...its the last thing stopping me going in the water...it may have never been changed..i really dont know...TIA ..
MEL.