Phelon Coils - KE4
- solitaire
- Posts: 1021
- Joined: Thu Aug 13, 2009 4:02 am
- CMBA Member: 511
- Location: Cheselbourne - Nr Dorchester
Phelon Coils - KE4
Hi - I could do with some advice on this one, - is it good practice to glue the HT lead into the coil, as it has a tortuous bend through the stator plate - just 2cm from the coil?
- Rapier
- Site Admin
- Posts: 13964
- Joined: Thu Feb 05, 2009 5:16 pm
- CMBA Member: 569
- Location: West Glos
Re: Phelon Coils - KE4
Remind me, are these the screw in type, like OMC coils? I've never had to glue them in.
Fasten bra straps and remove dentures...
- solitaire
- Posts: 1021
- Joined: Thu Aug 13, 2009 4:02 am
- CMBA Member: 511
- Location: Cheselbourne - Nr Dorchester
Re: Phelon Coils - KE4
Not screw in Rapier - just pushed onto a spike..........
Re: Phelon Coils - KE4
I used polyurethane adhesive to bond / seal the lead into the case on my original OMC coils. These like yours feature just a basic metal "nail" rather than a self tapping screw of the Sierra parts. I use the adhesive not only to help hold the wire in place but also to seal out the moisture.