Pics to follow, but these outboards are for sale from my collection.

Bought over a period of 5 years in order to use on current and future projects; they were all better looking than the normal rubbish on ebay and were worth saving from the BBQ people...

The OMCs are within the mechanical abilities of most people, with a reasonably basic tookit and the Clymer and Seloc manuals available. Parts and spares are available off the shelf in this country, but are far cheaper in the US when currency exchange rates are good!

Sadly I have little time to play any longer and would prefer that it be on the water rather than in my garage, so...

1. 1960 Evinrude Big Twin 40hp short shaft with pull start, converted to electric start on cowl, compression relief removed. Runs with new coils, new condensers. New impellor supplied for you to fit

http://www.youtube.com/watch?v=9quoa7foNzg

http://www.youtube.com/watch?v=KXAWhKorPaw

http://www.youtube.com/watch?v=d84xqPvWfr4

2. SOLD - 1968 Evinrude Big Twin 40hp short shaft with pull start, converted to electric start, long loom needs final connections boat side – Runs with new coils, new condensers and points and impellor

http://www.youtube.com/watch?v=45DryJzwrEI


3. 1971 Evinrude Ski Twin 40hp short shaft, manual start, new coils, new condensers. New impellor supplied for you to fit – £400

4. 1959 Evinrude 18hp ‘Golden Jubilee’ short shaft manual start, was electric start, repaired damage to steering bracket and saddle narrowed for some reason. Runs with new carb bits. Supplied with previously running near complete 1959 GJ 18hp (scavenged electrics for my Johnson – all parts available off the shelf) . – £180

5. SOLD - 1950s Atco Boatimpellor, ex Charles Pugh (no relation) collection, single cylinder air cooled Villiers based, 3hp? Direct drive. Previously restored, needs decals for authenticity. Runs well

http://www.youtube.com/watch?v=rCVd1ZmwJEo
http://www.youtube.com/watch?v=T9GD6jFgJKw

6. SOLD _ 1994 Yamaha 40hp 3 cylinder Autolube, rare short shaft, easy pull manual start. Modern motor, a joy, runs well, quiet and very responsive, recent anode and impellor. With 13 pitch prop, 701 remotes, cables and kill switch.
http://www.youtube.com/watch?v=xZ4pwRP7Spk

7. SOLD _- 1969 Evinrude 4hp twin, AMAL carb (no high / low speed needles to fiddle with). Direct drive end of line model, bin clearance built in Belgium for the European market, without the shrouds, or recoil of the 40’s to 68 model. New coils, runs well, small chunk missing from impellor (found & discarded), so recommend replacement per normal. Also near complete, but stripped 1969 4hp supplied, plus starter recoil, tank and shroud (cowls) for a mid 60s version

http://www.youtube.com/watch?v=zu5RHo_83-8

Hi Rapier,what a beautiful collection of engines,i am currently looking for a 1960's 40hp engine cowl from an evinrude or gale of that erea so i can fit to my own engine to give that 60's apperance,would you have anything you are willing to sell please and thank you.Grant,

Hi Grant, I have two, but they may not be suitable. The Ski Twin 33 (1968) is on loan with a member (his was stolen) and the Johnson 40 may be too clunky (perhaps 1970ish, same style as 1960 onwards, but can't find the brochure for it). The Johnson is NOS with all it's lining intact but scratches from storage I think. Will dig it out and photograph if you need?

I also have a much more modern 40hp from post 72 when they went to a square lid for both Evinrude and Johnson. I think is 1979 but is very tidy & NOS, but doesn't have the opening lid (shown below).

Hi Rapier,thank you for your reply,i am a liitle confused though,would you be able to pm me so that maybe i could call you,i will pm you now with my number should you rather call me,you may not want to give your number out, many thanks and best regards.Grant

Just read my reply properly, can see why I confused. Will call you later. rgds

Added recent (this weekend) videos of the 1968 Evinrude Big Twin - see post above and..

http://www.youtube.com/watch?v=m21YE8lqg0s

1968 Big Twin 40hp sold, 50's Boatimpellor sold.

what have you got left looking for 2 x 40hp long and short shaft
and are you going to windamere

Hi Howard, 1 &3 still available - no plans to do Windermere; did the Last Blast in 2004, lovely, but don't agree with the ban.

Are you going to CARDIF,which 2 are left,is there something wrong with website.or is it my computer, something change but i can`t explain it